Customer question from Jul 23, 2016, 12:37:42 PM
symptoms
- airbag dash light is flashing plus airbag warning light is on
Description
Replaced both seatbelt retainers as they had both deployed after I had a shunt into another car( airbags did not deploy). Lights are still flashing.
Answer from Jul 23, 2016, 7:53:30 PM
Hello , thanks for your question in the autoaid Community.
Your described fault Code means: LF/Driver Frontal Deployment Loop (Single Stage or Stage 1) Resistance Low
This Problem Comes from the front Airbag, its an internal fault, because the resistance is low.
If the resistance is high, the Plug or Wrap spring, airbag slip ring is faulty.
Sorry, i would like to say better Things.
Greetings
Team autoaid
Your described fault Code means: LF/Driver Frontal Deployment Loop (Single Stage or Stage 1) Resistance Low
This Problem Comes from the front Airbag, its an internal fault, because the resistance is low.
If the resistance is high, the Plug or Wrap spring, airbag slip ring is faulty.
Sorry, i would like to say better Things.
Greetings
Team autoaid
Answer from Jul 27, 2016, 10:02:20 PM
Hi thanks for trying to help with my question about error code B0022. I am not sure if the fault you describe is the same as the code reads - B0022 permanent PASSENGER PRETENSIONER CIRCUIT HIGH RESISTANCE. Is there any chance you could explain further as to all the parts that might need further checks or replacing which might give the same code as mentioned above. For example I read that the steering wheel airbag squib might be affected too with this error code? Thanks again.
Answer from Jul 28, 2016, 7:17:50 PM
Hello, i had look at original Opel fault codes, that means the following:
B0022 LF/Driver frontal deployment loop (single stage or stage 1) resistance low.
You could check the following:
Enclose the Steering Airbag and read after this the fault codes from the SRS ECU.
Then have this fault Code Change..
But, i could say only, be safe for work at the pyrotechnic System.
Greetings
Team autoaid
B0022 LF/Driver frontal deployment loop (single stage or stage 1) resistance low.
You could check the following:
Enclose the Steering Airbag and read after this the fault codes from the SRS ECU.
Then have this fault Code Change..
But, i could say only, be safe for work at the pyrotechnic System.
Greetings
Team autoaid
